Receiver Replacement - Digital Radio

RECEIVER REPLACEMENT - DIGITAL RADIO

REMOVAL PROCEDURE
1. Remove the rear seat.

IMPORTANT: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.




2. Disconnect the electrical connector.
3. Remove the receiver fasteners.
4. Remove the receiver from the vehicle.

INSTALLATION PROCEDURE




1. Install the receiver to the vehicle.
2. Install the receiver fasteners.

Tighten the fasteners to 3 N.m (26 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the electrical connector.
4. Install the rear seat.
5. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup.