Sunroof Module Assembly Replacement

SUNROOF MODULE ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE
1. Remove the headliner.






2. Cycle the glass panel to the rear.
3. Disconnect the electrical connector from the sunroof module.
4. Remove the front and rear sunroof drain hoses.
5. Remove the bolts that secure the sunroof module to the roof.
6. With an assistant, lower and remove the sunroof module assembly.

INSTALLATION PROCEDURE






1. With an assistant, position the new sunroof module assembly into the roof opening.
2. Install the bolts which secure the sunroof module assembly to the roof and tighten the bolts by hand.
3. Place a 12 mm (0.47 in) pin into the sunroof module alignment holes.
4. Remove the alignment pins.

NOTE: Refer to Fastener Note in Service Precautions.

Tighten the bolts to 9 N.m (80 lb in).

5. Install the front and rear sunroof drain hoses.
6. Connect the electrical connectors to the sunroof module.
7. Secure the harness to the sunroof module.
8. Adjust the sunroof window.
9. Verify the proper operation of the sunroof before securing the headliner.
10. With an assistant, install the headliner.