40. Piston and Connecting Rod Assemble

Piston and Connecting Rod Assemble

^ Tools Required
- J 25070 Heat Gun or equivalent





1. Install 1 retaining clip (121).
2. Apply clean engine oil to the piston pin bore, piston pin, and connecting rod pin bore.





3. Use the J 25070 or equivalent in order to heat the piston to approximately 70°C (158°F).





4. Assemble the piston and connecting rod with the alignment marks (1) on the same side.
5. Install the piston pin (119) and clip (121).





6. Install the piston rings (122).





7. The top compression ring (1) has a 1D identification mark. The second compression ring (2) has a 2C identification mark. The manufacturing identification marks must face the top of the piston.





8. Using a feeler gage, measure the ring-to-groove clearance.
^ Top compression ring clearance - new: 0.055 - 0.08 mm (0.0022 - 0.0031 inch)
^ Top compression ring clearance - service limit: 0.15 mm (0.006 inch)
^ Second compression ring clearance - new: 0.03 - 0.055 mm (0.0012 - 0.0022 inch)
^ Second compression ring clearance - service limit: 0.13 mm (0.005 inch)





9. Rotate the piston rings in order to position the end gaps. Do not position any ring gap at the piston thrust surface. Do not position any ring gap in line with the piston pin and pin bore.
^ Top compression ring (1)
^ Oil spacer ring (1)
^ Oil rings (2, 4)
^ Second compression ring (3)
^ Piston pin (5)