92. Engine Prelubing

Engine Prelubing

^ Tools Required
- J 45299 Engine Preluber
- EN 46333 Oil Pressure Testing Adapter





1. Important: A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.

Remove the engine oil filter (410) and fill with clean engine oil.

2. Notice: Refer to Fastener Notice in Service Precautions.

Install the oil filter.
Tighten the oil filter to 12 Nm (106 inch lbs.).
3. Remove the oil pressure switch (1).
4. Install the EN 46333.





5. Install the flexible hose to the EN 46333 and open the valve.
6. Pump the handle on the J 45299 in order to flow a minimum of 1-1.9 liters (1-2 quarts) engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
7. Close the valve and remove the flexible hose and adapter from the engine.
8. Install the oil pressure sensor to the engine.
Tighten the switch to 18 Nm (13 ft. lbs.).
9. Top-off the engine oil to the proper level.