Intake Air Temperature (IAT) Sensor 2 Replacement

INTAKE AIR TEMPERATURE (IAT) SENSOR 2 REPLACEMENT

REMOVAL PROCEDURE




1. Turn the ignition OFF.
2. Disconnect the IAT sensor harness connector.
3. Remove the IAT sensor from the side of the intake manifold (5).

INSTALLATION PROCEDURE




1. Install the IAT sensor to the side of the intake manifold (5).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the IAT sensor to 18 N.m (13 lb ft).

2. Connect the IAT sensor harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.