3. Accumulator Valve Body Assembly Installation

Accumulator Valve Body Assembly Installation





1. Install 2 8 x 14 mm spacer plate locating pins (451) into the servo valve body assembly.
2. Install the accumulator valve body spacer plate (450) on top of the servo valve body assembly.





3. Place the manual shift detent roller (935) between the accumulator valve body spacer plate (450) and the accumulator valve body assembly (495).

4. Important: The manual valve (235) must be turned in the correct position for the roller pin (937) to clear.

Insert the manual shift detent roller pin (937) through the following components:
^ Accumulator valve body spacer plate (450)
^ Servo valve body assembly (325)
^ Control valve body assembly (250)
5. Seat the end of the manual shift detent roller pin (937) into the locating hole in the torque converter housing (150).
6. Install the 8 x 62 mm 4th clutch apply fluid passage pipe (214) into the correct oil passage located in the top side of the control valve body assembly (250).
7. Install the accumulator valve body (495) on top of the accumulator valve body spacer plate (450).





8. Install the following accumulator valve body bolts:
^ A M6 x 1.0 x 60 mm bolt (477)
^ 3 M6 x 1.0 x 85 mm bolts (483)
^ 4 M6 x 1.0 x 95 mm bolts (482)
^ 2 M6 x 1.0 x 110 mm bolts (476)
^ A M6 x 1.0 x 125 mm bolt (479)
^ A M6 x 1.0 x 140 mm bolt (478)





9. Notice: Refer to Fastener Notice in Service Precautions.

Tighten the bolts in the sequence shown.
^ Tighten all bolts to 12 Nm (106 inch lbs.).





10. Install the following passage pipes into the accumulator valve body (495).
^ Mainshaft lube fluid pipe (475) 8 x 85 mm
^ 1st clutch control fluid pipe (480a) 8 x 151.5 mm
^ Coast clutch fluid pipe (480b) 8 x 151.5 mm
^ 4th clutch control fluid pipe (481) 8 x 40 mm