19. Torque Converter and Differential Housing Installation

Torque Converter and Differential Housing Installation

^ Tools Required
- J 36850 Assembly Lubricant





1. Apply J 36850 to the prong-side mating surface of a drive sprocket thrust washer.
2. Install the thrust washer onto the torque converter and differential housing assembly.





3. Notice: Use extreme care when applying sealant. Ensure the bead of sealant does not exceed 1 - 2 mm (0.04 - 0.08 inch). Excess sealant inside the transmission may cause restrictions resulting in various performance and noise complaints.

Important: Anaerobic sealant GM P/N 22722716 is the only authorized sealant that should be applied to the mating surfaces.

Important: Ensure the bead of sealant is centered on the mating surface between the bolt holes, and on the inside mating surface around the bolt holes.

Apply a 1 - 2 mm (0.04 - 0.08 inch) bead of sealant GM P/N 22722716 to the mating surface of the transmission case assembly.





4. Carefully install the torque converter and differential housing assembly on the transmission case assembly.





5. Notice: Refer to Fastener Notice in Service Precautions.

Secure the torque converter and differential housing assembly to the transmission case assembly with 22 NEW bolts.
^ Tighten the bolts to 28 Nm (21 ft. lbs.) in the sequence shown.