25. Case Cover Assembly Assemble

Case Cover Assembly Assemble

^ Tools Required
- J 44337 Build Plate Assembly





1. Ensure that the driven pulley retainer extension (1) is properly aligned to the case cover assembly.





2. Ensure that the drive belt assembly is installed and that the driven pulley assembly is still in the compressed position.

3. Important: When installing the case cover assembly onto the drive and driven pulley assemblies, ensure that the follower is positioned properly on the drive pulley.

Position the case cover assembly onto the drive and driven pulley assemblies.





4. Install the retaining ring for the drive pulley bearing.





5. Notice: Refer to Fastener Notice in Service Precautions.

Important: Ensure that the bolt holes in the driven pulley retainer extension are properly aligned with the bolt holes in the driven pulley bearing retainer.

Install the driven pulley bearing retainer and 6 bolts.
^ Tighten the bearing retainer bolts - 8 mm hex head to 5 Nm (44 inch lbs.) in the sequence shown.
^ Tighten the bearing retainer bolts - 10 mm hex head to 9 Nm (80 inch lbs.) in the sequence shown.





6. Install the drive pulley bearing retainer and 3 nuts.
^ Tighten the bearing retainer nuts to 11 Nm (8 ft. lbs.) in the sequence shown.





7. Notice: When releasing the spring force on the driven pulley assembly, slowly pull up on the two clamp handles. A rapid release of the spring force may cause damage to the belt assembly.

Using the J 44337, slowly pull up on the two clamp handles in order to release the spring force on the driven pulley assembly.
8. Remove the U-shaped ring from the driven pulley.





9. Inspect the case cover seal on the driven pulley cover for damage. Replace if necessary.





10. Install the 2 NEW driven pulley cover seals and the NEW case cover O-ring seal on the case cover assembly.

11. Important: Do not install all 4 of the bolts used to secure the driven pulley cover to the case cover assembly. Two of the bolt holes are used for attaching the case cover lifting bracket.

Install the driven pulley cover and the 2 bolts on the case cover assembly.
^ Tighten the bolts to 11 Nm (8 ft. lbs.).





12. Inspect the case cover seal on the drive pulley cover for damage. Replace if necessary.





13. Install the 2 NEW drive pulley cover seals on the case cover assembly.

14. Important: Do not install all 4 of the bolts used to secure the drive pulley cover to the case cover assembly. Two of the bolt holes are used for attaching the case cover lifting bracket.

Install the drive pulley cover and the 2 bolts on the case cover assembly.
^ Tighten the bolts to 11 Nm (8 ft. lbs.).





15. Notice: Avoid damage to the belt ringsets. Damage to the ringsets may cause the belt to become inoperative.

Remove the 2 tie straps from the belt assembly.