Speedometer and/or Odometer Inaccurate or Inoperative

Speedometer and/or Odometer Inaccurate or Inoperative

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The instrument panel cluster (IPC) displays the vehicle speed based on the information from the engine control module (ECM). The ECM converts the data from the vehicle speed sensor to a 4000 pulses/mile signal. The ECM sends the vehicle speed information via class 2 serial data circuit to the IPC in order to display the vehicle speed and miles traveled.

Diagnostic Aids

Check for the following DTCs:

DTC B1000

Circuit/System Testing

1. Ignition OFF, raise the vehicles drive wheels.
2. Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.

• If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.

3. Verify that the odometer is operating properly.

• If the odometer is not operating properly, replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Refer to Programming and Relearning Programming and Relearning