Flywheel to Torque Converter Bolt Replacement

Flywheel to Torque Converter Bolt Replacement

Tools Required
* J 37096 Flywheel Holder
* J 37623 10 1/2 Inch Pinion Bearing Remover

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.




2. Remove the torque converter cover.




3. Use the J 37096 in order to rotate the flywheel and access the torque converter bolts.
4. Use the J 37096 to hold the flywheel.




5. Remove the flywheel to torque converter bolts.

Installation Procedure




1. Install the flywheel to torque converter bolts.

Notice: Refer to Fastener Notice.

2. Use the J 37623 to hold the flywheel.

Tighten the bolts to 63 N.m (47 lb ft).




3. Install the torque converter cover.
4. Lower the vehicle.