Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust

Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust

Removal Procedure




1. Remove the engine mount strut and bracket. Refer to Engine Mount Strut Replacement - Right Side (Service and Repair) and Engine Mount Strut Bracket Replacement - Right Side (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (7) from the bank 1 exhaust camshaft position (CMP) sensor (6).




3. Remove the CMP sensor bolt and sensor (1).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the CMP sensor (1) and bolt.

Tighten the bolt to 10 Nm (89 lb in).




2. Connect the engine wiring harness electrical connector (7) to the bank 1 exhaust CMP sensor (6).
3. Install the engine mount strut and bracket. Refer to Engine Mount Strut Replacement - Right Side (Service and Repair) and Engine Mount Strut Bracket Replacement - Right Side (Service and Repair).