Operation CHARM: Car repair manuals for everyone.

C0292




DTC C0292

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0292 1A
- VSES Combination Sensor Circuits Bias Level Out of Range

DTC C0292 39
- VSES Combination Sensor Circuits Internal Electronic Failure

Circuit/System Description

The electronic brake control module (EBCM) supplies an ignition voltage to the yaw sensor and monitors the signal circuits back to the EBCM.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

* An internal failure in the yaw/lateral sensor.
* The yaw/lateral sensor bias level are out of range.

Action Taken When the DTC Sets

* The EBCM disables the VSES for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Non 2 Mode Hybrid) (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Testing

Ignition ON, verify that DTC C0292 is not set.

If DTC is set, replace the yaw sensor. If the DTC resets, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Vehicle Yaw Sensor Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming