C056E
DTC C056E (without HP5)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provide an overview of each diagnostic category.
DTC Descriptor
DTC C056E 42
- ECU Hardware Performance Calibration Data Set Not Programmed
Circuit/System Description
After replacement of the power steering control module (PSCM), the PSCM must be configured with the proper tuning profile using the service programming system (SPS).
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
This DTC will set if the PSCM has not undergone SPS reprogramming.
Actions Taken When DTC Sets
* DTC C056E 42 is stored in memory.
* The driver information center (DIC) displays the SERVICE POWER STEERING warning message.
* Steering assist is set to a default level.
Conditions for Clearing the DTC
* A current DTC will clear after the PSCM has been configured with the proper tuning profile.
* A history DTC will clear after 100 consecutive malfunction-free ignition cycles from when the PSCM has been configured with the proper tuning profile.
Reference Information
Schematic Reference
Power Steering Schematics ()
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Power Steering System Description and Operation (without HP5) (Description and Operation)Power Steering System Description and Operation (with HP5) (Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
Verify DTC C056E 4B is not set.
If DTC is set, perform the steering wheel angle and torque calibration procedure. If the DTC resets, replace the PSCM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for PSCM replacement, setup, and programming