Exhaust Manifold Heat Shield Replacement - Right Side

Exhaust Manifold Heat Shield Replacement - Right Side (LY7 or LCS) (3.6L)

Removal Procedure




1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LY7) (Service and Repair)Fuel Injector Sight Shield Replacement (LCS) (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (4).
3. Remove the HO2S electrical connector retainer (5) from the retainer clip.




4. Remove the exhaust manifold heat shield bolts (1).
5. Remove the exhaust manifold heat shield (2).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the exhaust manifold heat shield (2).
2. Install the exhaust manifold heat shield bolts (1) and tighten to 22 Nm (16 lb ft).




3. Connect the engine harness electrical connector (3) to the HO2S electrical connector (4).
4. Install the HO2S electrical connector retainer (5) to the retainer clip.
5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LY7) (Service and Repair)Fuel Injector Sight Shield Replacement (LCS) (Service and Repair).