Oil Filter: Service and Repair

Engine Oil and Oil Filter Replacement (LY7) (3.6L Without Hybrid)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Place a drain pan under the oil pan drain plug.
3. Remove the oil pan drain plug (1). Allow the oil to drain completely.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the oil pan drain plug (1) and tighten to 20 Nm (15 lb ft).




5. Place the drain pan under the oil filter.
6. Remove the oil filter. Allow the oil to drain completely.

Installation Procedure




1. Lubricate the NEW oil filter gasket with clean engine oil.
2. Tighten the oil filter to 30 Nm (22 lb ft).
3. Lower the vehicle.
4. Fill the engine with oil to the appropriate mark.
5. Start the engine and inspect for leaks.