Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Removal Procedure




1. Remove the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (1) from the bank 2 intake camshaft position (CMP) sensor (8).




3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.

Installation Procedure




1. Install the CMP sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the CMP sensor bolt. Tighten the bolt to 10 Nm (89 lb in).




3. Connect the engine wiring harness electrical connector (1) to the bank 2 intake CMP sensor (8).
4. Install the engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (Service and Repair).