C12F2

DTC C056D, C127A-C127C, C12F2-C12F6, or C12FE

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provide an overview of each diagnostic category.

DTC Descriptors
DTC C056D 00
- Electronic Control Unit Hardware

DTC C056D 3C
- Electronic Control Unit Hardware Internal Communication Failure

DTC C127A
- Electronic Brake Control Module RAM Performance

DTC C127B
- Electronic Brake Control Module Processor Performance

DTC C127C
- Electronic Brake Control Module Self-Test Malfunction

DTC C12F2
- ABS Left Rear Isolation Solenoid Valve Circuit Shorted

DTC C12F3
- ABS Left Rear Isolation Solenoid Valve Performance

DTC C12F4
- Dynamic Rear Proportioning Solenoid Valve Performance

DTC C12F5
- ABS Right Rear Isolation Solenoid Valve Circuit Shorted

DTC C12F6
- ABS Right Rear Isolation Solenoid Valve Performance

DTC C12FE
- ABS Pump Pressure Loss

Circuit/System Description

The electronic brake control module (EBCM) detects an internal malfunction.

Conditions for Running the DTC

* Ignition ON.
* Ignition voltage is greater than 10 V.

Conditions for Setting the DTC

The EBCM detects an internal malfunction.

Action Taken When the DTC Sets

* The EBCM disables the antilock brake system (ABS), traction control and the vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Reference Information
Schematic Reference

Antilock Brake System Schematics (2 Mode Hybrid) (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Antilock Brake System - Hybrid)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Verify DTC C056D is not set.

If DTC is set, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming