Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. If equipped with all wheel drive (AWD), remove the transfer case.
3. Disconnect the engine wiring harness electrical connector (2) from the crankshaft position (CKP) sensor.




4. Remove the crankshaft sensor bolt.
5. Remove the crankshaft sensor.

Installation Procedure




1. Install the crankshaft position sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the crankshaft position sensor bolt and tighten to 10 Nm (89 lb in).




3. Connect the engine wiring harness electrical connector to the CKP sensor.
4. If equipped with all AWD, install the transfer case. 5. Lower the vehicle.
6. Perform the Crankshaft Position System Variation Learn procedure.