Power Steering Cooler Pipe/Hose Replacement

Power Steering Cooler Pipe/Hose Replacement (LY7)

Removal Procedure

1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (Air Cleaner Outlet Duct Replacement).
2. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Service and Repair).
3. Place drain pans under the vehicle as needed.




4. Compress the power steering cooler pipe clamp (1) and disconnect the power steering cooler pipe (2) from the remote power steering fluid reservoir.




5. Disconnect the power steering cooler pipe fitting (1) from the power steering gear.
6. Unclip all power steering cooler pipe routing brackets.
7. Remove the power steering cooler pipe from the vehicle.

Installation Procedure

1. Position the power steering cooler pipe to the vehicle.
2. Reconnect all power steering cooler pipe routing brackets to the vehicle.





Caution: Refer to Fastener Caution (Fastener Caution).

3. Connect the power steering cooler pipe fitting (1) to the power steering gear and tighten the fittings to 25 Nm(18 lb ft).




4. Compress the power steering cooler pipe clamp (1) and connect the power steering cooler pipe (2) to the remote power steering fluid reservoir.
5. Clean any excess fluid from the vehicle and remove the drain pans.
6. Install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Service and Repair).
7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (Air Cleaner Outlet Duct Replacement).
8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair).