Evaporative Emission Control Canister: Service and Repair

Evaporative Emission Canister Replacement

Removal Procedure

Warning

Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.




1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disconnect the fuel tank wiring harness electrical connector (1) from the evaporative emission (EVAP) canister vent solenoid valve.




3. Disconnect the fuel tank vapor line quick connect fitting (4) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
4. Disconnect the chassis EVAP line quick connect fitting (1) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
5. Disconnect the EVAP canister line quick connect fitting (2) from the fuel tank fresh air line (3). Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).




6. Remove the EVAP canisters nuts (2).
7. Remove the canister (1) from the vehicle underbody.

Installation Procedure




1. Position the EVAP canister (1) to the underbody studs.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the EVAP canister nuts (2). Tighten the nuts to 8 Nm (71 lb in).




3. Connect the EVAP canister line quick connect fitting (2) to the fuel tank fresh air line (3). Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
4. Connect the fuel tank vapor line quick connect fitting (4) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
5. Connect the chassis EVAP line quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).




6. Connect the fuel tank wiring harness electrical connector (1) to the EVAP canister vent solenoid valve.
7. Lower the vehicle.