Fuel Gage

Inline Fuel Connector:

Fuel Gage Resistance Table:

1. Disconnect the in-line fuel connector located in the rear compartment on the driver side behind the carpet.
2. Using tester SA92O5Z (or equivalent), and a digital multimeter (set to the OHMS scale), connect the leads to terminals B and C of the connector going to the front of the vehicle
3. Turn ignition to the RUN position (do not start engine).
4. Set resistances as shown in the table.

If the IP cluster fuel gage is not accurate, service is by cluster replacement only. After replacing the IP cluster, repeat the above procedure to verify proper operation.