Sunroof / Moonroof Module: Service and Repair

SUNROOF MODULE ASSEMBLY

REMOVAL

1. Remove headliner as outlined in "Headliner Removal" procedure.






2. Remove map lamp base assembly from roof console assembly and disconnect wire connector to sunroof switch.

3. Remove connector position assurance (CPA) device from sunroof relay box to body wiring harness connector and disconnect connector.






4. Disconnect sunroof drain hoses from sunroof module.






5. Remove fasteners from sunroof module and remove sunroof module.

INSTALLATION

1. With sunroof glass installed, install sunroof module positioning sunroof glass in sunroof opening allowing sunroof glass to determine fore/aft and side-to-side alignment of sunroof module.

2. Install sunroof module fasteners.

Torque: 14 Nm (124 in-lbs)






3. Connect sunroof drain hoses to sunroof module.

4. Connect body wiring harness to sunroof relay box harness and install CPA device.






5. Connect sunroof wiring harness connector to sunroof switch in map lamp on roof console assembly base and install map lamp base.

6. Install headliner as outlined in "Headliner Installation" procedure.

7. Adjust sunroof glass to 1 mm (0.40 in.) below roof surface at front and 1 mm (0.40 in.) above roof surface at rear by loosening sunroof glass attaching screws and moving sunroof glass.