Circuit 817E. 817A, 817
CIRCUIT 817E, 817A and 817Function:
This circuit supplies a vehicle speed signal to the passive restraint control module from the PCM through the I/P junction block.
With the ignition in RUN, voltage present should be approximately two volts less than system voltage.
CIRCUIT 817E
Location:
Connects the PCM connector cavity J2A02 to the I/P engine inline connector cavity T
Type:
Green and White 22 gage wire Check for OPENS/SHORTS.
CIRCUIT 817A
Location:
Connects the I/P body inline connector cavity T to I/P junction block connector cavity D.
Type:
Green/White 22 gage wire
Repair:
Check for OPENS/SHORTS.
CIRCUIT 817
Location:
Connects the I/P junction block connector cavity A3 to passive restraint control module connector cavity H.
Type:
Green/White 22 gage wire