Components

Description:

Brake Switch

Check connections and terminals for damage, tightness, or corrosion.

Check switch resistance pin A (gray connector) to pin C or D (black connector).

Switch resistance: Open when brake not depressed. Less than one ohm when brake depressed.

Repair/Replace as needed.

If this component is good, got to the next item indicated on the "Complaint-Condition" chart.

Rear Turn/Stop Lamp Assemblies

Check connections and terminals for damage, tightness, or corrosion.

Check resistance through the bulb sockets. Repair/replace as needed.

If this component is good, go to the next item indicated on the "Complaint-Condition" chart.

Front Park/Turn Lamp Assemblies

Check connections and terminals for damage, tightness, or corrosion.

Check resistance through the bulb sockets. Repair/replace as needed.

If this component is good, go to the next item indicated on the "Complaint-Condition" chart.

Bulbs

Check connections and terminals for damage, tightness, or corrosion.

Visually inspect the bulb. Check resistance through the bulb.

Repair/replace as needed.

If this component is good, go to the next item indicated on the "Complaint-Condition" chart.

I/P Cluster

Refer to "Instrument Panel Cluster".

Center High Mount Stop Lamp

Check connections and terminals for damage, tightness, or corrosion.

Check resistance through the bulb sockets. Repair/replace as needed.

If this component is good, go to the next item indicated on the "Complaint-Condition" chart.

Turn/Hazard Switch

Refer to Lever Combination Switch (LCS) for testing. Combination Switch

Repair/replace as needed.

If this component is good go to the next item indicated on the "Complaint-Condition" chart.