Rear Camber & Caster

CASTER
Rear wheel caster is not adjustable.

CAMBER

Fig. 1 Front & Rear Camber Adjustment.:

1. Loosen two strut to knuckle fasteners, then pull or push to adjust.
2. If more than 1.5 degrees of camber is desired, check for bent suspension components.
3. If suspension is good, proceed as follows:
a. Raise and support vehicle.
b. Remove wheel assembly.
c. Remove strut to knuckle attaching bolts, then separate knuckle from strut bracket.
d. Using a file or grinder, remove material from strut bracket lower hole, Fig. 1.
e. To increase negative camber, remove from outside hole, to increase positive camber, remove from inside hole.
f. Torque strut to knuckle attaching bolts to 148 ft. lbs.
g. Install wheel assembly and torque wheel lug nuts to 103 ft. lbs., then recheck camber setting and lower vehicle.