5TH Shift Fork Retainer Clip

1. If the 5th/Reverse actuator retainer clip is properly secured to the shift fork shaft, perform the following procedures to inspect, and replace if necessary, the 5th shift fork retainer clip.

2. Remove the transaxle end cover assembly according to procedures in the appropriate year "Manual Transaxle & Clutch Service Manual" and inspect for proper installation of the 5th shift fork retainer clip.

^ If the 5th shift fork retainer clip is properly secured to the shift fork shaft, re-install the end cover assembly according to procedures in the appropriate year "Manual Transaxle & Clutch Service Manual." After end cover assembly has been installed, refer to appropriate complaint/condition chart in the service manual to diagnose and repair the condition.

^ If the 5th shift fork retainer clip is not properly secured to the shift fork shaft:

a. remove the 5th shift fork retainer clip.

b. Replace with a new 5th shift fork retainer clip according to procedures in the appropriate year "Manual Transaxle & Clutch Service Manual."

c. Re-install the transaxle end cover assembly according to procedures in the appropriate year "Manual Transaxle & Clutch Service Manual."

^ If the 5th shift fork retainer clip is missing, it must be retrieved to prevent possible damage to other transaxle components.

a. Retrieve the 5th shift fork retainer clip.

b. Inspect transaxle components for damage from the 5th shift fork retainer clip and replace any damaged components as necessary.

c. Re-install the transaxle end cover assembly according to procedures in the appropriate year "Manual Transaxle & Clutch Service Manual."