Powertrain Control Module (PCM) Replacement

NOTE: Record preset radio stations and clock time. Disconnect negative battery cable.


REMOVAL

I/P Upper Trin Panel:

1. Remove I/P upper trim panel outer cover fillers by carefully lifting up at clip locations, starting at the rear above end cap. (SC1/SC2 only)

I/P Retaining Bolt Caps:

2. Remove I/P bolt caps by carefully prying with a small flat head screwdriver.
3. Remove I/P upper trim panel screws.

Upper Trim Panel Removal:

4. Lift I/P upper trim panel at clip locations on rear edge to disengage clips.
5. Pull I/P upper trim panel rearward out of clips at bottom of windshield.

NOTE: Be careful, when removing or replacing I/P upper trim panel, not to damage VIN plate.

6. Remove I/P upper trim panel.

NOTE: Be careful, when removing upper trim panel, not to damage the upper trim panel seal (SL/SW only).

I/P Upper Trim Panel:

7. Remove I/P upper trim pad sound insulator.

PCM Mounting:

8. Disconnect PCM electrical connector from under instrument panel.

NOTE: Do not pull on the connectors or wires to remove the PCM. This could back out a terminal and cause an intermittent connection.

9. Loosen PCM attachment out at cross car beam and lift PCM upward (towards windshield) to disengage PCM from ABS/PCM bracket.


INSTALLATION

1. Lower PCM into ABS/PCM bracket while guiding attachment stud into slot in cross car beam.

NOTE: Torque is critical to preserve the integrity of the plastic insulator on the PCM case. Damage to the PCM can result from over torque of the nut.

2. Install and torque nut.
- Torque: 10 N.m (89 in.lbs.)

3. Install PCM connectors.

I/P Upper Trim Panel Installation:

4. Install I/P upper trim pad sound insulator.

NOTE: Make sure to tuck in all flaps.

NOTE: Be sure I/P upper trim panel seal is correctly seated on forward edge before installing upper trim panel (SL/SW only).

5. Install I/P upper trim panel into clips at base of windshield.

NOTE: Be careful when removing or replacing upper trim panel, not to damage VIN plate.

6. Lower I/P upper trim panel, making sure I/P upper trim panel alignment tabs interlock with windshield garnish slots (SL/SW only).
7. Push down at clip locations to secure.

I/P Upper Trin Panel:

8. Install I/P upper trim panel screws.
9. Install I/P bolt cap.

I/P Retaining Bolt Caps:

10. Install I/P upper trim panel outer cover fillers (SC1/SC2 only).
11. Reprogram PCM.
12. Verify operation. If diagnostic trouble codes (DTCs) are present, refer to the specific code chart.


IMPORTANT: Following PCM replacement, the SERVICE telltale will flash. This is a normal function of the PCM. When a service replacement PCM is installed and properly programmed, the PCM will learn the crankshaft notches for misfire diagnosis. This procedure flashes the SERVICE telltale. Description and Operation