Installation

1. Attach E-Z entry cable to front of new inboard adjuster (P/N 21050248) and install retaining clip.





2. Install passenger seat adjuster linkage wire to passenger seat inner adjuster.





3. Install two passenger seat inner adjuster bolts.

Torque: 27 N.m (20 ft-lbs)





4. Install inboard recliner to inboard adjuster using two passenger seat inboard recliner bolts.

Torque: 27 N.m (20 ft-lbs)





5. Apply Loctite(R) 242 Threadlocker (P/N 21485277) or equivalent to passenger seat side mount buckle. Install passenger seat side mount buckle and bolt.

Torque: 75 N.m (55 ft-lbs)

6. Install passenger seat adjuster finish inner cover and two screws.





NOTICE:
Timing of the seat adjuster tracks in relationship to each other is essential for proper installation. Handle the seat assembly with extreme care to prevent damage to seat mounting surfaces.

7. Activate passenger seat adjuster assemblies by releasing the adjuster lever.

8. Position passenger seat cushion assembly forward to allow the pawls attached to the seat track to lock in the third windows on both seat adjuster tracks.

9. Carefully install passenger seat in vehicle.





10. Apply Loctite(R) 242 Threadlocker (P/N 21485277) or equivalent to four passenger seat bolts and install the following three passenger seat bolts in the following order:

(1) Rear inboard

(2) Rear outboard

(3) Front outboard

Torque: 35 N.m (26 ft-lbs)

11. Move passenger seat assembly to full rearward position by activating the seat adjuster lever.

12. Install front inboard passenger seat bolt (4).

Torque: 35 N.m (26 ft-lbs)

13. Sit in passenger seat, and buckle and unbuckle the seat belt.

14. Activate adjuster lever and move seat to various positions along seat tracks to ensure proper operation. The seat should lock at each desired position.

15. From the outside of the vehicle, check the operation of the E-Z entry feature.

^ Pull up on the recliner release lever and the seatback should tilt forward and the seat assembly should move to the full-forward position.

^ Move the seatback to its upright position, and slide the seat assembly rearward until it locks in place.

16. Affix the Campaign Completion Label to the radiator core support.