Enabling the SIR System

1. Turn ignition switch to LOCK position and remove key.
2. Connect yellow two-way SIR connector at the base of steering column and install Connector Position Assurance (CPA) device to connector.





3. Connect yellow two-way passenger inflator module pigtail and install Connector Position Assurance (CPA) device to connector.





4. Install upper trim panel insulator

IMPORTANT: Make sure to tuck in all flaps.





IMPORTANT: Be sure upper trim panel seal is correctly seated on forward edge before installing upper trim panel.

5. Install upper trim panel into clips at base of windshield.

IMPORTANT: Be careful, when removing or replacing upper trim panel, not to damage VIN plate.

6. Bower panel, making sure upper trim panel alignment tabs interlock with windshield garnish slots.
7. Push down at clip locations to secure.





8. Install and tighten screws.
9. Install screw caps.
- Torque: 2.3 N.m. (20 inch lbs).
10. Install AIR BAG fuse to I/P junction block.
11. Turn ignition switch to the RUN position and verify that the AIR BAG warning lamp flashes seven times and then turns Off. If it does not operate as described, perform the "SIR Diagnostic System Check."