Coupe

Choose an anchor location shown in the figure that is most convenient for the customer. Additional hardware is available if you require more than one child restraint.

1. Lower rear seat backs.

2. On 1991-1996 Coupes, for both weld nut locations:





IMPORTANT:
Illustration shown is for 1991-1996 Coupes, 1997-1999 Coupes are similar.

a. Locate desired weld nut from under the bottom of the rear window trim finish panel and pierce a hole in the rear window trim finish panel with an awl.

b. Leave the awl in the rear window trim finish panel and select a deep well socket with the same outside diameter as the spacer included in the parts package.

c. Center the deep well socket over the end of the awl and using a utility knife, trim around the perimeter of the socket. Remove socket and awl from rear window trim finish panel.

d. Remove cut-out section of rear window trim finish panel.

3. On 1997-1999 Coupes, select desired weld nut and remove the fastener to expose the weld nut.

Illustration Key

(1) Two Weld Nut Locations

4. Install child tether anchor bracket, spacer and fastener into appropriate hole.

Torque: 20-30 N.m (15-22 ft-lbs)

5. Raise rear seat backs.





Illustration Key

(1) Two Weld Nut Locations

(2) Anchor Bracket

(3) Spacer

(4) Bolt

(5) Trim

(6) Steel Panel Assembly

(7) Weld Nut