Wagon

Choose an anchor location shown in the figure that is most convenient for the customer.

Additional hardware is available if you require more than one child restraint.

1. Raise rear liftgate.

2. Remove rear sill molding.

3. Remove cargo carpet and spare wheel cover.

NOTICE:
Improper installation of the top tether anchor may cause damage to wiring harness in the same area.

4. Avoiding the wiring harness, position bracket in the forward direction and install tether screw/bolt provided in tether anchor package.

Torque: 20-30 N.m (15-22 ft-lbs)





Illustration Key

(1) Three Anchor Locations





5. Remove rear sill molding tether access panel at location of tether bracket installation.

6. Install rear sill molding by pushing on molding at clip locations until clips engage.

7. Install spare wheel cover and cargo carpet.

8. Close rear liftgate.