Blower Relay - Removal and Installation

Removal

1. Locate blower relay on the driver's side in the footwell area. The blower relay is located in the instrument panel (I/P) wire harness, approximately 305 mm (12 in.) from the powertrain control module (PCM) I/P connector.

IMPORTANT:
The blower relay is the first component taped to the I/P harness from the PCM I/P connector end.

2. Remove black tape from around the blower relay.

3. Disconnect blower relay from base by disengaging locking tab and gripping the base while pulling the relay away from the base.





Installation

1. Install blower relay into base.

2. Using high quality electrical tape, tape blower relay to harness.