Engagement Switch

REMOVAL
1. Disable the SIR system.
Disabling the SIR System
2. Remove screw caps on the steering wheel by carefully prying with a small flat head screwdriver.
3. Remove inflator module screws.
4. Lift inflator module out of steering wheel.
5. Remove integral connector lock device with small flathead screwdriver. Disconnect connector and remove inflator module.
6. Disconnect cruise control switch and remove two screws and cruise control switch.

INSTALLATION
1. Install cruise control switch and connect switch connector

Torque: 3.2 NM (28 in. lbs)

2. Connect inflator module to wiring harness and install integral connector lock device.

IMPORTANT: Always replace inflator module fasteners with new fasteners. Never reuse old fasteners.

3. Install inflator module into steering wheel and torque fasteners, being careful not to cross thread fasteners.

Torque: 10 NM (89 in. Lbs)

4. Snap on screw covers.
5. Enable the SIR system.
Disabling the SIR System

ROAD TEST
Perform road test and verify cruise control operation.

IMPORTANT: During road test, check operation of the cruise control switches (Resume, Accelerate, On, Off, broke switch).