A/T - Whine Noise in 2nd Gear Only
BULLETIN NO.: 98-T-35ISSUE DATE: September, 1998
GROUP/SEQ. NO.: Transaxle-05
CORPORATION NO.: 887204
SUBJECT:
Transaxle Whine Noise in 2nd Gear Only (Replace 2nd/Reverse Drive Gear)
MODELS AFFECTED:
1998 - 1999 Saturn vehicles equipped with Base Automatic (MP6) Transaxles built after 1998 VIN WZ312775 through 1999 VIN XZ114349.
CONDITION:
Some customers may comment about excessive whine noise in 2nd gear only that is related to vehicle speed (pitch increases with vehicle speed). The noise becomes audible soon after the 1-2 upshift and is present until the transaxle upshifts to 3rd gear. The whine noise is most noticeable while driving the vehicle in Manual D2.
CAUSE:
Improperly machined gear surface on the 2nd/Reverse Drive gear.
CORRECTION:
Disassemble transaxle and replace the 2nd/Reverse Drive Gear assembly (P/N 21003233).
PROCEDURE
1. Confirm that VIN is greater than 1998 VIN WZ312775 and less than or equal to 1999 VIN XZ114349.
2. Verify the whine noise matches the symptoms outlined above. Drive the vehicle in D2 to isolate 2nd gear. Next, place the vehicle in D4 and drive vehicle normally, allowing the transaxle to reach 3rd and 4th gears. Determine if the noise is present once the vehicle reaches 3rd or 4th gear.
^ If the noise is still present in other gears, refer to the diagnosis section of the appropriate model year Automatic Transaxle Service Manual.
^ If the whine noise is only present in D2, continue with step 3 of this procedure.
3. Remove the transaxle from the vehicle. (Refer to "Automatic Transaxle Removal" in the "Out-Of-Vehicle Service" section of the appropriate model year Automatic Transaxle Service Manual.)
4. Remove Input and Output Shafts per the service manual procedure.
5. Remove the 2nd/reverse thrust bearing. Use care not to scratch shaft surface.
6. Remove and replace the 2nd/Rev Drive Gear (P/N 21003233).
7. Reassemble and reinstall transaxle into vehicle according to procedure in the appropriate model year Automatic Transaxle Service Manual.
PARTS REQUIREMENTS:
21003233 Gear Asm - 2nd & Rev
CLAIM INFORMATION:
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System using the appropriate Electronic Labor Time Guide and Labor Operation Code K7135, (Second/Reverse Gear and Hub Assembly - Replace).