Temperature Cable

REMOVAL





1. Depress center pins inward to release radio/HVAC controller cover push pin fasteners.

IMPORTANT: Do not push center pins through fasteners.

2. Remove fasteners and pull radio/HVAC controller cover rearward.
3. Disconnect traction control/fog lamp/rear defog electrical connector if equipped.





4. Remove radio screws.
5. Push spring clips in through D-holes on both sides of radio brace.
6. Pull radio out slightly to access rear of radio.





7. Disconnect electrical connector and antenna.
8. Remove radio.





9. Disconnect blower switch, A/C-Recirc and lighting electrical connectors. Remove electrical harness clip from module boss.





10. Remove temperature cable from HVAC control by squeezing lock tabs together while pulling cable housing straight up.
11. Remove cable from pin by pulling straight up. (Service cable shown in illustration.)





12. Reach under dash and release temperature cable hold down clip by carefully pushing up on plastic tab while pushing down on top of cable.
13. Slide cable off of temperature door hook.
14. Remove temperature cable. (Service linkage shown in illustration.)

INSTALLATION





1. Install temperature cable over temperature door hook.
2. Snap temperature cable hold down clip over temperature cable holder.





3. Install temperature cable over pin.
4. Install temperature cable housing into channel and push down to lock.





5. Connect blower switch, A/C-Recirc and lighting electrical connectors.

IMPORTANT: Make sure wiring harnesses do not interfere with control lever movement.

6. Install electrical harness clip to module boss.





7. Connect electrical connector and antenna to radio.





8. Install radio.

IMPORTANT: Make sure spring clips are seated in D-holes on both sides.

9. Install and tighten screws.

Torque: 2.5 N.m (22 in-lbs)





10. Connect traction control/fog lamp/rear defog electrical connector, if equipped.
11. Install radio/HVAC controller cover. Push in at clip locations.
12. Install push pins and lock.