Backup Lamp Switch: Adjustments

Back Up Light Switch (Automatic Transaxle): Switch Adjustment:

Switch Adjustment (w/Automatic Transaxle)

IMPORTANT: While adjusting the Park Neutral Position (PNP) switch, always rotate the switch towards the engine to achieve continuity. A diagnostic trouble code P0706 could result if this procedure is not followed.

1. Place transaxle in D (Drive). Use ohmmeter or continuity tester to check for continuity across terminals on selector switch. Rotate the park neutral position switch from the left fender towards the engine until continuity is achieved.

2. Tighten switch to case bolts. After switch-to-case bolts have been tightened, check continuity.
Torque: 14 Nm (124 in-lbs)

IMPORTANT: Digital Volt/Ohm Meter (DVM) with audible continuity test is preferred. Do not stick probe in PNP switch terminal hole; use male terminals on PNP switch or faulty readings could occur.

3. Connect electrical connectors.