ABS/PCM Bracket

REMOVAL
1. Remove ABS control module. Refer to ABS Control Module.
2. Disconnect PCM connectors from under I/P.
3. Loosen PCM attachment nut at cross car beam and lift PCM upward (towards windshield) to disengage ABS/PCM bracket.

NOTICE: Do not pull on the connectors or wires to remove the PCM. This could back out a terminal and cause an intermittent connection.

4. Remove nuts holding ABS/PCM bracket to steering column support bracket.
5. Remove ABS/PCM bracket.

INSTALLATION
1. Install ABS/PCM bracket stud through hole in steering column support bracket.
2. Install and torque nut.
^ Torque: 6 Nm (54 in. lbs.)

3. Lower PCM into bracket while guiding attachment stud into slot in cross car beam.

NOTICE: Torque is critical to preserve the integrity of the plastic insulator on the PCM case. Damage to the PCM can result from over torque of the nut.

4. Torque nut.
^ Torque: 10 Nm (89 in. lbs.)

5. Connect PCM electrical connectors.
6. Install ABS control module. Refer to ABS Control Module.