Fog/Driving Lamp Switch: Service and Repair

Fog Lamp Switch: Removal/Installation:

REMOVAL
1. Remove radio/HVAC controller cover fasteners, by depressing center pins inward. Pull fasteners out of cover.

IMPORTANT: Do not push center pins through fasteners.

2. Pull radio/HVAC controller cover rearward.
3. Press down on locking tab located in center of electrical connector and disconnecting connector from switch assembly.
4. Depress plastic switch retainers and remove switch assembly from Radio/HVAC controller cover.

IMPORTANT: It is not necessary to remove switch assembly from cover for bulb replacement. Using a flat blade screw driver turn bulb holder 1/8 turn counter clockwise and remove from switch assembly.

INSTALLATION
1. Snap switch assembly into radio/HVAC controller cover and connect electrical connector.
2. Install radio/HVAC controller cover. Push in at clip locations.
3. Reset push pins in fasteners, install fasteners in cover and lock.