Wiper Arm Replacement

REMOVAL




1. Remove wiper arm finish cap by pulling upward on cap at pivot location.




2. Remove wiper arm fastener.
3. Lift wiper arm assembly away from windshield and remove wiper arm from pivot shaft.

INSTALLATION




1. On drivers side, position wiper blade assembly between locator dot in blacked out area of windshield and bottom of dot matrix in windshield.
2. On passengers side, position wiper blade assembly at locating line in windshield.

NOTE: Use new nuts. Torque retention of old nuts may not be sufficient.

3. Install fastener.

Torque: 28 N.m (21 ft-lbs)




4. Install wiper arm finish cap.