Output Shaft Clearance Measurement

1. Assemble output shaft with 5th driven gear as shown. Use old nut and torque.

Torque: 150 Nm (110 ft. lbs.)

NOTICE: The 5th driven gear has an identifier groove marked on its face. Install the gear with the groove facing up.





2. Measure clearance between 3rd/4th cluster gear and 2nd driven gear.

Clearance:
Standard: 0.20 mm - 0.35 mm (0.008 inch - 0.014 inch)

3. Measure clearance between 1st driven gear and 1st driven gear thrust washer.

Clearance:
Standard: 0.20 mm - 0.0495 mm (0.008 inch - 0.019 inch)