Removal

CAUTION: Make sure vehicle is properly supported and squarely positioned on hoist. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which components are being removed.





1. Position vehicle on hoist.
2. Remove air induction system and air filter box.





3. Disconnect upper transaxle cooler line from transaxle.

IMPORTANT: To remove upper cooler line from transaxle squeeze plastic tabs at connector and pull line out of connector. The plastic retainer remains on the line.

4. Use line wrench to remove upper transaxle cooler line from radiator.
5. Remove upper cooler line from vehicle.





6. For lower transaxle cooler line, raise vehicle. Remove front splash shield fasteners and remove splash shield.
7. Use a line wrench to remove lower transaxle cooler line from radiator.
8. Disconnect lower transaxle cooler line from transaxle.

IMPORTANT: To remove cooler line from transaxle squeeze plastic tabs at connector and pull line out of connector. The plastic retainer remains on the line.

9. Remove cooler line from vehicle.





10. Remove plastic retainer from line using small screwdriver to pry tabs away from line (pry where indicated by arrows) far enough to slip retainer over rib on line.
11. Inspect plastic retainer for cracks or other signs of fatigue. Replace if necessary.
12. Remove and replace transaxle cooler line fitting if leakage is present.

Torque: 15 Nm (11 ft. lbs.)

IMPORTANT: If replacing cooler line fitting, case threads must be clean and dry. Replacement cooler line fitting comes with a pre-applied sealant.