Window Regulator Assembly

REMOVAL

NOTE: Do not damage insulator panel when removing regulator.




1. Remove door trim panel. Outer panel is removed in illustration to show location.




2. Remove window.
3. Disconnect harness from power regulator.
4. Remove rear regulator bolt, loosen remaining four, and slide regulator assembly out of door.

INSTALLATION
1. Slide regulator assembly into door and position regulator with attachment bolts.
2. Install window to regulator assembly.
3. Install wiring harness connector to motor.
4. Torque regulator assembly bolts.

Torque: 10 N.m (89 in-lbs)

5. Check regulator for proper operation.
6. Install trim panel.