Installation

CAUTION: Make sure vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which components are being removed.





1. Install lower transaxle cooler line to radiator.

Torque: 14 Nm (10 ft. lbs.)

2. Install plastic retainer to lower transaxle cooler line and install retainer into cooler line fitting at transaxle.

IMPORTANT: Push line into fitting until it bottoms out and verify by gently trying to pull the line out of the fitting.





3. Install front splash shield and install front splash shield fasteners.
4. Lower vehicle.
5. Install plastic retainer to upper transaxle cooler line and install retainer into cooler line fitting at transaxle.

IMPORTANT: Push line into fitting until it bottoms out and verify by gently trying to pull the line out of the fitting.

6. Install upper transaxle cooler line to radiator.

Torque: 14 Nm (10 ft. lbs.)





7. Install air filter box and install air induction system.

Torque: 10 Nm (89 inch lbs.)

8. Check fluid level and add as necessary. (Refer to "Fluid Level Checking" in Automatic Transmission Fluid for fill procedure.)
9. Run engine and check for leaks.