Installation

1. Install switch to transaxle and install switch to case bolts. Do not tighten bolts at this time.
2. Install control lever-to-manual shift shaft.

NOTICE: If manual shift shaft is rotated excessively, internal damage to the transaxle range switch may occur.

3. Prevent the manual shift shaft from rotating by holding control lever while installing retaining nut.

Torque: 12 Nm (106 inch lbs.)

4. Install cable to control lever and adjust cable. (Refer to "Shift Cable Adjustment" in this manual.)
5. Before tightening transaxle range switch-to-case bolts, proceed to Adjustment procedure.