Right Hand Drive

1. Position generator on lower cylinder block bracket and install the lower attachment bolt. Install upper attachment bolt and torque both bolts.

Generator attachment Bolts:
Torque: 32 N^m (24 ft-lbs)

NOTE: If stud is not held and stud rotates, the plastic insulator will crack and/or break causing generator to fail.


IMPORTANT: The battery terminal fusible link wire (between the starter and generator) should be orientated on the generator between a 10 and 11 o'clock position.

Generator Removal:

2. Install the generator regulator connector and install the fusible link to the generator. When installing the fusible link, use the generator output stud wrench (SA9401C) to prevent the output (B+) stud from rotating.

Generator Positive Terminal:
Torque: 10 N^m (89 in-lbs)
3. Install accessory drive belt.
4. Install side splash shield.
5. Install right wheel.
Torque: 140 N^m (103 ft-lbs)
6. Lower vehicle on hoist.
7. Connect battery negative cable.
Torque: 17 N^m (151 in-lbs)