Installation

1. Obtain new service replacement latch-to-lock cylinder rods.

^ P/N 244O7368 for driver side (red markings)

^ P/N 24407369 for passenger side (green markings)

2. Install new lock rod to lock cylinder.

3. Install latch assembly to door structure and ensure outside door handle lock rod engages in latch assembly. Install and torque bolts in the following order:

Torque: 10 N.m (89 in-lbs)

a. Top bolt

b. Bottom bolt

c. Middle bolt

4. Snap lock cylinder rod to latch mechanism.

5. Position rear window guide into door. Install by aligning locating tab on guide with door structure and pushing up.





6. Install rear window guide bolt.

Torque: 10 N.m (89 in-lbs)

7. If equipped, attach door lock wiring harness retainer to rear window guide.

8. Install inside door handle release lever.





9. Attach inside door handle release lever actuator rod to latch assembly and secure rod to guide clip on door structure.

10. If equipped, connect power door lock wiring harness connector to latch assembly.





11. Install water deflector at top rear edge of door only.

12. Install remaining areas of water deflector. Ensure a tight and wrinkle free seal along all adhesive areas.





13. Attach manual lock rod to latch mechanism and install lock rod retainer.

14. Check function of outside door lock cylinder with key to make sure door unlocks and stays unlocked when outside door handle is pulled.





15. On vehicles equipped with illuminated front door trim panels, hold door trim panel away from door structure enough to connect wiring harness connector.





16. Lower window.

17. Install weatherstrip at rear edge of window.

18. Align top of door trim panel to door structure (front first, then rear) and push down to engage top attachment locations.

19. Apply pressure to door trim panel side to seat retainers and secure panel to door structure.

20. Install lower door trim panel fasteners.

Torque: 1.5 N.m (13 in-lbs)

21. On non-power window equipped vehicles, install window crank handle.

22. Connect tweeter speaker wiring harness connector.

23. If equipped with power locks or power mirrors, route wiring harnesses through door handle opening.

24. Tuck door handle under trim panel upper weatherstrip and install door handle fasteners.

Torque: 1.2 N.m (10 in-lbs)

25. Snap door handle grip into place.

26. Snap tweeter speaker cover into place.





27. Snap mirror patch into place.





28. On power equipped vehicles, connect power lock switch and power mirror switch wiring harness connectors and snap switches into place. (On non-power equipped vehicles, snap covers into place.)

29. If equipped, check function of power door locks, power windows, and power mirrors.

30. Check function of front speakers to ensure proper operation.