Tail Lamp: Service and Repair

Tail Lamp Replacement (Sedan)

Removal Procedure






1. Open the rear compartment.
2. Pull back the side carpet to gain access to the tail lamp.
3. Remove the nuts from the tail lamp.
4. Gently pull the tail lamp housing straight back.
5. Disconnect the electrical connector from the tail lamp.

Installation Procedure






1. Connect the electrical connector to the tail lamp.
2. Position tail lamp to the quarter panel and push in until fully seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the nuts to the tail lamp.

Tighten
Tighten the nuts to 3.5 Nm (31 lb in),

4. Reposition the side carpet.
5. Close the rear compartment.