Rear Compartment Lid Lock Cylinder Coding

REMOVAL




1. Unhook return spring from case and pawl.
2. Remove cap from lock cylinder by inserting thin blade screwdriver between cap and case and carefully prying cap from case.

IMPORTANT: When shutter is removed, the shutter springs may fall out.

3. Remove shutter and shutter springs.




4. Insert key and rotate a quarter turn clockwise. Slide cylinder from housing.
5. Remove return spring and pawl from case.




6. Remove key and push tumblers out of lock cylinders using a thin bladed screwdriver.
7. If necessary, remove sidebar assembly by pushing it inward while tapping the cylinder, causing it to fall out.




8. Select the correct tumblers for the desired code by the number stamped on the tumbler.

IMPORTANT: Make sure sidebar and tumbler springs are in place before installing tumblers.




9. Install tumblers by applying downward pressure until they lock into place.
10. To check coding of the cylinder, insert key. If coding is correct, tumblers and sidebar will be flush with cylinder with key inserted.
11. Slide return spring over pawl and install pawl into groove of lock case.
12. For assembly, oil the lock set with a light oil or graphite lubricant and reverse Steps 1 through 4.