Fluid - M/T: Service and Repair

IMPORTANT: The manual transaxle is filled with fluid at the manufacturer and requires no routine oil changes. If it is determined that the fluid needs to be changed due to contamination or similar issue, follow this procedure.

IMPORTANT: To ensure that all sediment within the transaxle is suspended in the fluid, the fluid should only be drained after it has reached a normal operating temperature of 88 - 93°C (190 - 200°F). Normal operating temperature is reached after approximately 25 km (15 miles) of highway driving.

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST.

1. Position vehicle on hoist and raise vehicle.





CAUTION: THE TRANSAXLE FLUID IS HOT. CAUTION MUST BE TAKEN TO PREVENT PERSONAL INJURY WHEN TRANSAXLE FLUID DRAINS FROM THE TRANSAXLE.

2. Remove transaxle drain plug (1). Allow at least five minutes for the fluid to drain completely.
3. Remove transaxle level plug (2).
4. Clean and apply thread sealant (P/N 21485278) to drain plug and install.
Torque: 50 Nm (37 ft. lbs.)
5. Using a funnel with a flexible spout or a quart bottle hand pump, add manual transaxle fluid (P/N 21018899) through level plug opening until fluid flows out.
6. Clean and apply thread sealant (P/N 21485278) to level plug and install.
Torque: 50 Nm (37 ft. lbs.)