Clutch Housing

Tools Required
- 87-91-204 Output Shaft Bearing Race Sleeve
- 87-92-236 Support
- 87-91-220 Drift, Main Shift Rod Bushing

DISASSEMBLY





1. Press out input shaft bearing race using 87-91-204. Use 87-92-236 as a base for pressing operation.





NOTICE: Be careful not to score or damage clutch housing with screwdriver.

2. Remove shift control shaft seal with a screwdriver as shown.





3. Tap out shift control shaft bushing using 87-91-220.





4. Tap out axle seal and discard.





NOTICE: When driving out the differential bearing race, tap equally on opposite sides of the race to avoid damaging the race bore.

5. Tap out differential bearing race using a punch and hammer.

Tools Required
- SA9113T Axle Seal Installer
- SA9172G Ball Detent Handle
- 87-92-236 Support
- 87-91-220 Drift, Main Shift Rod Bushing
- 87-92-210 Support, Differential Bearing
- 87-90-312 Drift, Bearing Race, Input Shaft
- 83-90-114 Sleeve
- 87-91-311 Sleeve, Bearing Driver Shaft

ASSEMBLY





1. Press in new differential bearing race using axle seal installer SA9113T and handle SA9172G. Use sleeve 87-92-236 as a base for pressing operation.





2. Install new axle seal using axle seal installer SA9113T and handle SA9172G.





3. Install shift control shaft bushing using 87-91-220.





4. Fill shift control shaft seal lips with grease and drive into clutch housing using 87-92-210 and a hammer. The spring side of seal should face in.





5. Press in new input shaft bearing race using bearing race installer 83-90-312. Use sleeve 83-90-114 and sleeve 87-91-311 as a base for pressing operation.